TI LP-MSPM0G5117

This article describes specifics for the TI LP-MSPM0G5117 evaluation board.

Preparing for J-Link

• Connect the J-Link to J103.
• Power the board via USB1.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LP-MSPM0G5117.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V7.20
• Hardware: TI LP-MSPM0G5117
• Link: File:VENDOR DEVICENAME TestProject ES V720.zip