TDK-Micronas HVC 5481G Application Board

From SEGGER Knowledge Base
Jump to navigation Jump to search

This article describes specifics for the TDK-Micronas HVC 5481G Application Board evaluation board.

TDK-Micronas HVC5481G board.JPG

Preparing for J-Link

  • Connect the J-Link to the "Debug" connector (X7).
  • Power the board via PCB header (X1).
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

TDK-Micronas HVC5481G connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TDK-Micronas HVC 5481G Application Board.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://kb.segger.com/index.php?title=TDK-Micronas_HVC_5481G_Application_Board&oldid=25009"