STK-A31C122-KYN-A
Jump to navigation
Jump to search
The STK-A31C122-KYN-A is an A31C122 evaluation board.
Preparing for J-Link
- Connect your J-Link to the SWD connector CN1, using jumper wires as follows:
| CN1 Pin | J-Link Pin | Signal |
|---|---|---|
| DIO | 7 | SWDIO |
| CLK | 9 | SWCLK |
| RST | 15 | RESET |
| VDD | 1 | VTref |
| GND | 4 | GND |
Note: For a more reliable, simpler solution, the SEGGER Flying Wire Adapter is recommended.
- Remove both SWD jumpers JP3.
- Power the board via the USB-C connetor and set the the external power switch SW1 to ON.
- Alternatively power the board via the external power connector J4.
- Verify the Connection with J-Link Commander. The output should look as follows:
Example Projects
Hello World
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ADuCM355. It outputs "Hello World!" to the Debug Terminal in a loop.
Setup
- J-Link software: V9.88
- Embedded Studio: V8.26
- Hardware: A31C122
- Link: File:A31C122 HelloWorld.zip