Renesas FPB-RA8E1

This article describes specifics for the Renesas FPB-RA8E1 evaluation board.

Preparing for J-Link

• Connect the J-Link to J13.
• Power the board via USB.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-RA8E1.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V7.20
• Hardware: Renesas FPB-RA8E1
• Link: File:Renesas R7FA8E1A TestProject ES V720.zip