Renesas FPB-RA0L1

This article describes specifics for the Renesas FPB-RA0L1 evaluation board.

Preparing for J-Link

• Connect USB-C cable to on-board J-Link (J10)

• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-RA0L1.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V8.22
• Hardware: Renesas FPB-RA0L1
• Link: File:Renesas FPB-RA0L1 TestProject ES V822.zip