Nuvoton MRider18-EB
Jump to navigation
Jump to search
This article describes specifics for the Nuvoton MRider18-EB evaluation board.
Preparing for J-Link
- Connect the J-Link to J15.
- Power the board via J20.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton MRider18-EB.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: Nuvoton MRider18-EB
- Link: File:Nuvoton NPCX997F TestProject ES V720.zip