Nordic nRF54L15-PDK

This article describes specifics for the Nordic semiconductor nRF54L15-PDK evaluation board.

Preparing for J-Link

• nRF54L15-PDK kit has on-board J-Link.
• Connect the board to host computer via USB TYPE-C connector (J3).
• Turn on the power using SW4 switch.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nordic semiconductor nRF54L15-PDK.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V8.16a
• Hardware: Nordic semiconductor nRF54L15-PDK
• Link: File:Nordic nRF54L15-PDK TestProject ES V816a.zip