NXP X-KW45B41Z-EVK
Jump to navigation
Jump to search
This article describes specifics for the NXP X-KW45B41Z-EVK evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support.
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Put a Jumper on J22 to activate the debug interface
- Connect the J-Link to the SWD header (J16)
- Power the board via external power supply (J14)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-KW45B41Z-EVK. It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.30
- Hardware: NXP X-KW45B41Z-EVK
- Link: File:NXP KW45B41Z83 TestProject ES V830.zip