NXP FRDM-MCXA266

This article describes specifics for the NXP FRDM-MCXA266 evaluation board.
File:NXP FRDM MCXA266 board.jpg

Preparing for J-Link

• Connect the J-Link to J14.
• Power the board via USB J15.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXA266.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V7.20
• Hardware: NXP FRDM-MCXA266
• Link: File:NXP MCXA266 TestProject ES 7V20.zip