NUCELO-MB2067-WS

This article describes specifics for the ST NUCELO-MB2067-WS evaluation board.

Preparing for J-Link

• Connect the J-Link to CN4 (DBG_IN).
• Power the board via USB.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCELO-MB2067-WS.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V9.30b
• Hardware: ST NUCELO-MB2067-WS
• Link: File:ST STM32G564RE TestProject ES V930b.zip