Microchip PIC32CXMTC-DB
Jump to navigation
Jump to search
This article describes specifics for the Microchip PIC32CXMTC-DB evaluation board. It can be used to test & verify Microchip PIC32CX-MTx device support.
Minimum requirements
- J-Link software V7.94a or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J20).
- Power the board via the power jack (J3).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip PIC32CXMTC-DB. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94a
- Embedded Studio: V8.18
- Hardware: Microchip PIC32CX2051MTG128
- Link: File:Microchip PIC32CX2051MTC128 TestProject ES V818.zip