Infineon PSoC C3 Control Card

From SEGGER Knowledge Base
Jump to navigation Jump to search

This article describes specifics for the Infineon PSoC C3 Control Card evaluation board.
Infineon PSoC C3 Control Card board.jpg

Preparing for J-Link

  • The board has a J-Link OB. Simply connect the board through the USB-C connector.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Infineon PSoC C3 Control Card connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Infineon PSoC C3 Control Card .
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://kb.segger.com/index.php?title=Infineon_PSoC_C3_Control_Card&oldid=22080"