Flasher Pro XL V8
Jump to navigation
Jump to search
This page contains the mechanical and electrical specifications of the SEGGER Flasher Pro XL V8.
For information on the general specifications as well as an overview of supported software features refer to Flasher Pro XL.
Specifications
| Specification | Value |
|---|---|
| Power supply | USB powered, maximum 140 mA (idle) |
| USB host interface | USB 2.0 (high speed); USB-C |
| Target interface | Male 20-pin IDC keyed box header with 0.1" pitch (2.54 mm); optional adapters available |
| Supported target interfaces | SPI, QSPI, 8051 C2, cJTAG, FINE, ICSP, IIC, ISP, JTAG, PDI, SPD, SWD, SWIM, UART, UPDI |
| Internal flash memory | 2 GB (TBW: 200 TB) |
| Max. target cable length | Recommended (delivered): 20 cm (8") Max. 2 m (6.5") allowed, but might reduce max. target-interface speed |
| Serial transfer rate between Flasher and target | Dependent on target interface; JTAG/SWD: 50 MHz |
| Supported target IO voltage | 1.2 - 5 V |
| Current drawn from target voltage sense pin (VTRef) | < 25 µA |
| Target supply voltage | 1.5 - 5 V |
| Target supply current | Max. 400 mA |
| Reset type | Open drain with 100 Ohms series resistor. Can be pulled low or tristated. |
| Operating temperature | +5 °C ... +60 °C |
| Storage temperature | -20 °C ... +65 °C |
| Relative humidity (non-condensing) | < 90% rH |
| Size (without cables) | 130 mm x 70 mm x 28 mm |
| Weight (without cables) | 126 g |
| Supported OS | Microsoft Windows (x86-64, Arm64), Linux (x86-64, Arm64), macOS (x86-64, Apple Silicon) |