Flasher PRO XL V7
Jump to navigation
Jump to search
This page contains the mechanical and electrical specifications of the SEGGER Flasher PRO XL V7.
For information on the general specifications as well as an overview of supported software features refer to Flasher PRO.
Specifications
| Specification | Value |
|---|---|
| Power supply | USB-powered, 500 mA if target is powered by Flasher PRO XL |
| USB host interface | USB 2.0 (High-Speed), USB Type B |
| RS232 host interface | RS232 9-pin |
| Target interface | Male 20-pin IDC keyed box header with 0.1" pitch (2.54mm), optional adapters available |
| Internal flash memory | 128 MB (TBW: 10 TB) |
| Max. target cable length | Recommended (delivered): 20 cm (8") Max. 2 m (6.5") allowed but might reduce max. target interface speed. |
| Serial transfer rate between Flasher PRO XL and Target | Max. target interface (JTAG, ...) speed: 50 MHz |
| Supported target voltage | 1.2 - 5 V |
| Current drawn from target voltage sense pin (VTRef) | < 25 µA |
| Target supply voltage | 5 V |
| Target supply current | Max. 400 mA |
| Reset type | Open drain with 100 Ohms series resistor. Can be pulled low or tristated |
| Operating temperature | + 5 °C ... + 60 °C |
| Storage temperature | - 20 °C ... + 65 °C |
| Relative humidity (non-condensing) | < 90 % rH |
| Size (without cables) | 121 mm x 66 mm x 30 mm |
| Weight (without cables) | 120 g |
| Supported OS | Microsoft Windows (x64/Arm), Linux (x64/Arm), macOS (x64/Apple Silicon) |