Flasher Compact V6
Jump to navigation
Jump to search
This page contains the mechanical and electrical specifications of the SEGGER Flasher Compact V6.
For information on the general specifications as well as an overview of supported software features refer to Flasher Compact.
Specifications
| Specification | Value |
|---|---|
| Power supply | USB-powered, 500 mA if target is powered by Flasher Compact |
| USB host interface | USB 2.0 (High-Speed), USB-C |
| Supported target interfaces | SPI, QSPI, 8051 C2, cJTAG, FINE, ICSP, IIC, ISP, JTAG, PDI, SPD, SWD, SWIM, UART, UPDI |
| Target interface | Male 20-pin IDC keyed box header with 0.1" pitch (2.54mm); optional adapters available |
| Max. target cable length | Recommended (delivered): 20 cm (8") Max. 2 m (6.5") allowed but might reduce max. target interface speed. |
| Serial transfer rate between Flasher Compact and Target | Depending on target interface; JTAG/SWD: 50MHz |
| Supported target voltage | 1.2 - 5 V |
| Current drawn from target voltage sense pin (VTRef) | < 25 µA |
| Target supply voltage | 5 V |
| Target supply current | Max. 400 mA |
| Reset type | Open drain with 100 Ohms series resistor. Can be pulled low or tristated |
| Operating temperature | + 5 °C ... + 60 °C |
| Storage temperature | - 20 °C ... + 65 °C |
| Relative humidity (non-condensing) | < 90 % rH |
| Size (without cables) | 70 mm x 45 mm x 18 mm |
| Weight (without cables) | 40 g |
| Supported OS | Microsoft Windows (x64/Arm), Linux (x64/Arm), macOS (x64/Apple Silicon) |