AmbiqMicro Apollo510 Lite Series EVB
Jump to navigation
Jump to search
This article describes specifics for the Ambiq Apollo510 Lite Series EVB evaluation board.

Preparing for J-Link
- To use the built-in J-Link OB debug probe, connect a USB-C cable to the Main USB port (J16). This port also supplies power to the board.
- To use an external J-Link probe or Flasher, connect it to the SWD/JTAG connector (J2 DEBUG HDR).
- Turn on the board, set the power switch (SW4) to the ON position.
- Verify the connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Ambiq Apollo510 Lite Series EVB.
It is a simple Hello World sample linked to run from internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: Ambiq Apollo510 Lite Series EVB
- Link: File:Ambiq Apollo510 Lite Series EVB TestProject ES V830a.zip