ST NUCLEO-WBA52CG
Jump to navigation
Jump to search
This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.
[PICTURE OF BOARD]
File:VENDOR BOARDNAME.jpg
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT] File:VENDOR DEVICE CONNECT.PNG
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip