Renesas EK-RA6M5: Difference between revisions
Jump to navigation
Jump to search
(Created page with "__TOC__ This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify Renesas RA6M5 support. =Minimum requirements= * J-Link...") |
No edit summary |
||
| Line 1: | Line 1: | ||
__TOC__ | __TOC__ | ||
This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify [[Renesas RA6M5]] support. | This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify [[Renesas RA6M5]] support. | ||
[[File:EK_RA6M5.jpg|450px]] | |||
=Minimum requirements= | =Minimum requirements= | ||
Revision as of 10:28, 7 April 2021
This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify Renesas RA6M5 support.
Minimum requirements
- J-Link software V7.00 or later
Preparing for J-Link
- Attach the board over the debug USB-port to your PC (J10 - J-LinkOB). This will power the board as well.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M5. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.00
- Embedded Studio:
- Hardware: Renesas EK-RA6M5
- Link: File:TestAPP ProgFlash RA6M5.zip