TI CC2340: Difference between revisions
Jump to navigation
Jump to search
(→Reset) |
|||
| Line 20: | Line 20: | ||
==Device Specific Handling== | ==Device Specific Handling== | ||
===Reset=== | ===Reset=== | ||
The device uses custom reset which performs a reset via the SACI interface: | |||
*In case of a valid application is programmed, the MCU will be halted on the reset vector (application entry point). | |||
*In case of no valid application is programmed, the MCU will be halted in a so called debug loop | |||
===Attach=== | ===Attach=== | ||
Revision as of 09:38, 17 May 2023
The TI CC2340 devices are Cortex-M0 based wireless MCUs.
Flash Banks
Internal Flash
| Flash Bank | Base address | Size | J-Link Support |
|---|---|---|---|
| Program Flash | 0x00000000 | 512 KB | 
|
| CCFG Flash | 0x4E020000 | 2 KB |
|
CCFG Flash
- Describe CCFG Flash restriction here.
!!!TBD!!!
Device Specific Handling
Reset
The device uses custom reset which performs a reset via the SACI interface:
- In case of a valid application is programmed, the MCU will be halted on the reset vector (application entry point).
- In case of no valid application is programmed, the MCU will be halted in a so called debug loop
Attach
Limitations
Flasher Stand-Alone Mode
Not supported yet. Support will be implemented soon.
Attach
Attach is not supported because a device specific initialization sequence is required.
Evaluation Boards
- TI LP-EM-CC2340R5 evaluation board: http://wiki.segger.com/TI_LP-EM-CC2340R5
Example Application
- TI LP-EM-CC2340R5 evaluation board: http://wiki.segger.com/TI_LP-EM-CC2340R5#Example_Project