Holtek HT32F125 Development Board

From SEGGER Knowledge Base
(Redirected from HT32F125 Development Board)
Jump to navigation Jump to search

This article describes specifics for the Holtek HT32F125 Development Board.

HT32F125.jpg

Preparing for J-Link

  • Connect your J-Link to the SWD header (CN4 or CN5)
  • Power the board via USB (CN1).
  • Verify the Connection with J-Link Commander. The output should look as follows:

HT32F125 Connect.png

Example Projects

Binary Counter

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Holtek HT32F125 Development Board. It uses D3 up to D5 as 3-bit binary counter.

Setup

Hello World

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the HT32F125. It outputs "Hello World!" to the Debug Terminal in a loop.

Setup

Retrieved from "https://kb.segger.com/index.php?title=Holtek_HT32F125_Development_Board&oldid=24341"